A typical vinyl house that was built in the early 1990s, you can see how faded the old siding is. The old vinyl siding pulls off the wall quite easily. There’s no building wrap behind the old siding, but we’re going to correct that because a good siding job starts with properly installed high-quality building wraps, and flashing around the windows, and doors. The corners and protrusions through the wall such as vents and wiring for lights. It’s important to make the home watertight at the end of each workday. The wrap is installed it’s time to put up some j-channel in preparation for the new siding. This step will be skipped depending upon your particular situation. Now install the steel tracking system that holds the brick this heavy-gauge steel is galvanized and polymer-coated. That’s what rubrics can give you a 50-year warranty. This system is very versatile where the installer is putting the rail in place for arch and Keystone which will go above all the windows. After the steel is securely attached, put the brick corner pieces in first they slide right in. The rest of the brick snap-in with the help of a rubber mallet. Brick tiles are cut from a full-sized brick into 1-inch slabs, then groove to fit securely into the rail. That’s why this system looks like real brick because it’s made from real brick. The house is getting an authentic molded brick with antique texture.
Exterior Ideas :brick and siding houses in Exterior.